Item Specifications:
Mtaerial:Rubber
Size:100x6mm
Package Quanqity:10Pcs/2 Sheet
Weight:32g
Function:Tire repair strips
Notes on the correct use of adhesive strips:
When you find a leak and perform a tire repair operation, please confirm the following points:
1. Mark the punctured part of the tire and pull out the puncture.
2. Use a tire repair probe to detect the direction of penetration of the hole, and insert the twitch along the direction of the hole to remove the dust and debris in the hole.
3. Cut one end of the rubber strip into an oblique opening and insert it into the hole in the front end of the pin tool, so that the length of the rubber strip at both ends of the hole is basically the same.
4. Insert the pin with the rubber strip into the tire along the broken hole, make sure the rubber strip is inserted 2/3 length (must make sure that the cold patch rubber strip penetrates the carcass to avoid sliding out after inflation), and rotate the pin 360 degrees before pulling it out Pin out.
5. The remaining tire repair rubber strip outside the tire, leave the remaining 5mm length on the tread and cut off.
Send Message
