Installation Guide:
Connection:
-Take Out The Wires From Pocket Inside The Gloves.
-Carefully Connect White Jumper With White Port & Black Jumper With Black.
Operation:
-Put Battery In Pocket, Upfront Angle On The Back Of Gloves, Where Button On The Battery Place On Day Wolf Logo. (For Reference See Instruction Image On Details page)
-One Button On Index Finger & One The Back Of The Hand On Battery Use Any Button To Switch On The Flashlight and Press Again to Adjust Heating Modes.
User Instructions:
Ø Charge The Batteries With or Without Removing From Glove's Wires Just Switched Off The Flashlight While Charging The Batteries.
Ø Put The Charging Port Upside The Pocket For Easy Charging.
Ø Charge The Battery For 1 to 2 Hours Until The Red Light Turns Green.
Ø Red Light illuminate While Charging.
Ø Green Light illuminate when Charging is Complete.
Ø Open the Battery Pocket inside the Gloves and Carefully Connect Black Wire with Black Connector and White Wire with White Connector.
Ø Put the Button Portion of Battery on the Upfront Side on Back of Gloves.
Ø Press Power Button Once to On & Press Again to Adjust Modes.
Ø It Is Recommended To Recharge The Battery At Least Once In Every Six Months To Keep It Usable (If product is not in use).
Ø For The Long Life of LED Gloves & Battery It Is Recommended to do not Plug & Unplug Battery Again and Again From Wires. Only Unplug When Don't Want To Use Gloves For Long Time.
Ø Remove Battery while Cleaning or Storing Gloves.
Ø Use Mild Detergent to Clean the Only the Spots and Air Dry Lying Flat.
Ø Hand wash is recommended for more safety.
Ø If Machine Wash then it is recommended to use sack bag to wash it.
Ø Do not Machine Dry or Use Bleach.
Send Message
