Dn50 Dn80 Dn100 Dn150 Aluminum Corrugated Pipe Flame Arrester, Flame Arrester, Gas Station Accessory

Flame arrester
pipe flame arrestor is a kind of installation on or near the pipe end of the pipe, the pipe to prevent the flames by vertical transmission and diffusion flame arrester, widely used in heating furnace fuel gas, natural gas, liquefied petroleum gas pipeline, and oil and gas recovery, gas purification, gas analysis, such as coal mine gas emission system, can effectively guarantee the safe operation of gas pipeline and gas use point. Wire flame arrester should be installed in the fuel gas or flammable liquid steam pipeline of the nozzle. When the nozzle tempering, flame arrester in wire mesh due to the wall effect is converted into heat energy that the flame is extinguished, prevent the flammable gas and combustible liquid vapor flame spread and prevent tempering and cause explosion.
Installation, maintenance: 1. In order to ensure the performance of the flame arrester to achieve the purpose of use, before the installation of flame arrester, must read this manual carefully, and check carefully signs are consistent with the outside line requirements.2. The flow mark in the flame arrester must be consistent with the medium flow direction.3. Check once every six months. Check whether there is fire layer congestion, such as deformation or corrosion defects.4. Blocked fire layer should be clean, ensure smooth each pore deformation or corrosion of the fireproof layer should be replaced.5. Clean the flame arrester core parts, should be used in high pressure steam, non corrosive solvent or compressed air purge, shall not adopt any sharp hardware scrub.6. Reinstall the fireproof layer, should update the gasket seal face is clean and no damage, shall not leak.

Flame arrester:
DN50
DN65
DN80
DN100
DN150
DN200
DN250

Yongjia Senpai Machinery Co., Ltd.

Aifei
Sales Manager
Website:http://zjspjx.en.made-in-china.com/