13600mAh Car Jump Starter Kit for 12V Vehicle (ZXBP002), Jump Starter, Car Jump Starter

1. Output Voltage at auto start end 12V
2. Size: 165*79*40MM
3. USB port: 5V, 2.1A
4. Charge mode: CC/CV 15V 1A
5. Start current: 200A
6. Peak current: 400A(3S)
7. Cycle life: 3000 times (Approx 2-3 years)
8. Operating temperature range: -40-85 °C
9. Operating temperature range: 0-85 °C
10. Capacity: 13600mAh

Functions:
1. Emergency jump start for 12V auto mobile.
2. Safe to use in extreme temperature condition.
3. High luminance and Multi-modes Led lighting.
4. Support to charge of various brands mobile, MP3/MP4, laptops(no any connector for the MACbook) and tablet.
5. Multiple safety protection design, to ensure the product have no defect.
  
Characteristics:
1. High safety: Using rare earth materials, In any case, no fire breaking out and no explosion, accompanying you through the journey with no worries.
2. Mini exquisite and protable, the battery is 1/5 volume of equivalent specification lead-acid batteries, is daily life necessity of self-driving travel and outdoor sports.
3. Easy to start, continuously trigger the auto mobile for over 30 times When the power is full. Even the power is less than 20%, it can still start up the engine for emergency.
4. Powerful LED luminance system: General lighting, SOS distress signal and bright flashing lighting.
5. Mobile power back up supply: Support to charging various digital product.
6. Ultra-large battery capacity: Charging various digital products up to 2-5 times.
7. Ultra-long cycle life for over 3000 times.
8. High temperature resistance safe to store in car and temperature up to 80-85°C degree during day parking.
9. Low-temperature safety performance of a battery.
Products Picture:


Accessories:


Package:

Special Note:
To start 12V car please make sure the product power capacity is 20% or above. Clamp the red jumper cable (i. E. The positive cable) to the dead car's positive battery terminal, which is marked with a "+. " Clamp the black jumper cable (i. E. The negative cable) to the booster car's negative battery terminal, which is marked with a " - ". Make sure that the clamp is firmly connected to the battery and then start the engine. Disconnect the jumper cable one by one after the engine started.