-Applying fuel spray atomization, the burn efficiency is high and the exhaust fulfills European environmental protection standards.
-High-voltage arc ignition, ignition current is only 1.5 A, and ignition time is less than 10 seconds
-Due to the fact that key elements are imported in the original package, reliabilty is high and service life is long.
-Welded by the most advanced welding robot, each heat exchanger has a good appearance and high coherence.
- Applying concise, safe and fully automatic program control; and highly precise water temperature sensor and over-temp protection are used to double safety protection.
-Suitable for preheating engine at cold start, heating the passenger compartment and defrosting the windshield in various types of passenger buses, trucks, construction vehicles and military vehicles.
| Type | YJP-Q16.3 | Motor operates in low temperature and warming ,defrosting of bus |
| Thermal flow(kw) | 16.3 | |
| Oil wear (kg/h) | 1.87 | |
| Voltage(v) | DC12/24V | |
| Power(w) | 170 | |
| Circulation method | Coolant pump | |
| Weight(kg) | 22 | |
| Main Application | Engine cold start and heating |
principle:
Under the operation of motor, oil is taken to jet by pump to produce oil fog under high speed air blow with motor circling. oil fog is burning under high voltage discharge of igniting electrode, its heat is sent to circling liquid in heat exchanger by conductive slice, under the operating of pump, liquid is taken to radiant equipment to make vehicle warm and defrost.
Installation
Selecting product type,installation is seemed to be more important, because it decides usage effect of warming system directly. Installation has five steps:
2.inlet-air of heater is ample, so a shutter (total area≥100cm2) should be cut in the side of cabin, and waste air is prohibitted to be inhaled to inlet-air pipe to affect the operation,air-exhausted pipes stretch to the outside of cabin.
3.Oil pipe (φ8×1) is made from nelon colophony, joints M14×1.5, pipes must be joint tightly. Difference of oil tank liquid surface and heater center is within ±500mm, distance between in-oil joint and surface of oil pipe is within 3m, heater pipes are single ,they can't be used with others pipe together.
4.Electric connection refers to circuit diagram.
5.Canalage of heater has reasonable arrangment,affusion is at the top , position of heater is as low as possible, pipe can't be converted into hard bend, pipes resistant-pressure>6kg/cm2
Currently being the largest stakeholders in China, we hold a domestic market share of 40% and then we export them around the globe particularly in Asia, Europe and Americas.
Q1. hat is your terms of packing?
Send Message
